 |
Specifications |
 |
| Model Numbers |
Geometry
Displacement
cm3/rev (cu.in/rev) |
Minimum
Adj.Flow
cm3/rev (cu.in/rev) |
Operation Pres.
MPa(PSI) |
Shaft Speed Range
r/min |
Approx.Mass
kg(lbs.) |
| Rated¡°2 |
Intermittent¡°1 |
Max. |
Min. |
Flange Mtg. |
Foot
Mtg. |
A10-
FR01B-12* |
10.0(.610) |
2 (.122) |
16(2320) |
21(3050) |
1800 |
600 |
5.1(11.2) |
¢w |
| A10-FR01C/H-12* |
8.5(18.7) |
A16-
*-R-01-*-*-K-32 |
15.8(.964) |
4 (.244) |
16(2320) |
21(3050) |
1800 |
600 |
16.5(36.4) |
18.7(42.1) |
A22
-*-R-01-*-*-K-32 |
22.2(1.355) |
6 (.366) |
16(2320) |
21(3050) |
1800 |
600 |
16.5(36.4) |
18.7(42.1) |
A37
-*-R-01-*-*-K-32 |
36.9(2.25) |
10 (.610) |
16(2320) |
21(3050) |
1800 |
600 |
28.0(61.7) |
32.3(71.2) |
A56
-*-R-01-*-*-K-32 |
56.2(3.43) |
12 (.732) |
16(2320) |
21(3050) |
1800 |
600 |
35.0(77.2) |
39.3(86.7) |
|
¡°1.Whenener setting pressure, make sure the full cut-off pressure never exceeds the maximum intermittent pressure.
¡°2.Care should be taken in cases of used ay a higher pressure than the rated pressure, because operating terms may be restricted. For example, if used as per maximum illustrated operating conditions, intermittent time at maximum flow is restricted to under 1/5 of one cycle time and under 6 seconds simultaneously. Conditions may vary according to the actual working pressure and delivery.
